Product ID:700W17, TT-P-24E TYPE II #27875 WHITE
MSDS Date:07/21/1989
FSC:8010
NIIN:00N031986
MSDS Number: BPKCH

GRIGGS PAINT

3602 S 16TH PLACE
PHOENIX, AZ 85040
US

Emergency Phone: 602-243-3293

Info Phone: 602-243-3293

Preparer: ROBERT COMMISSO

Cage: DO312

GRIGGS PAINT

PHOENIX, AZ 85040-1319 US

Telephone: 602-243-3293

Cage: DO312

2 @ 68F.

CAS: 8032-32-4

RTECS: OI6180000

Fraction By Weight: 25%

OSHA PEL 300 PPM;400 PPM STEL

ACGIH TLV: 300 PPM

TITANIUM OXIDE;(TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 15%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

TALC (POWDER), CONTAINING NO ASBESTOS FIBERS

CAS: 14807-96-6

RTECS: WW2710000

Fraction By Weight: 15%

OSHA PEL 0.2 FIBERS/CC

ACGIH TLV: 0.2 FIBERS/CC

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE/CHRONIC:DIRECT EYE CONTACT MAY
IRRITATE. PRLNGD/RPTD CNTCT MAY CAUSE SKIN IRRITATION. INHAL OF
HIGH CONCENTRATIONS OF VAPS MAY LEAD TO LUNG CHANGES, NAUS, VOMIT,
COUGH, PULM IRRIT & CNS DEPRESS. INGEST MAY CAUSE GI DISTURBANCES.
ASPIR OF MATL INTO LUNGS MAY CAUSE PNEUMONITIS, PULMONARY EDEMA AND
HEMMORHAGE.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:INHAL:BRTHG OF HIGH VAPOR CONCENTRATIONS MAY
CAUSE DROWSINESS/DIZZ, FATIGUE, FOLLOWED BY COMA. SKIN:PRLNGD/RPTD
CNTCT MAY CAUSE IRRIT/DERM. MAY BE ABSORBED THRU SKIN. PRLNGD/RPTD
EXPOS CAN CAUSE MOD I RRIT, DEFAT & DERM. INGEST:ASPIR INTO LUNGS
MAY CAUSE PNEUMIT, PULM EDEMA/HEMMORHAGE. INGEST:MAY CAUSE GI
DISTURBANCES.
Medical Cond Aggravated by Exposure:PRE-EXISTING DISEASES OR HISTORY OF
AILMENTS INVOLVING SKIN, CENTRAL NERVOUS SYSTEM, LIVER AND KIDNEY.

First Aid:EYE:IMMEDIATELY FLUSH WITH LARGE VOLUMES OF WATER FOR AT
LEAST 15 MINUTES. GET MD. SKIN:WASH THOROUGHLY WITH SOAP & WATER.
GET MD IF IRRITATION PERSISTS. INGEST:GET MD IMMEDIATELY. DO NOT
INDUCE VOMIT ING. DO NOT ATTEMPT TO GIVE ANYTHING BYMOUTH TO
UNCONSCIOUS PERSON. INHAL:MOVE TO FRESH AIR. SUPPORT BREATHING
(GIVE O2/ARTF RESP) .

Flash Point Method:TCC
Flash Point:100F,38C
Lower Limits:1%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT . WATER MAY BE INEFFECTIVE BUT MAY BE USED TO
COOL CNTNRS. IF WATER IS USED, FOG NOZZ PREF.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, ELECTRICAL EQUIPMENT, SPARKS AND OPEN FLAME. CLOSED
CONTAINERS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:STOP LEAK IF NO RISK INVOLVED. REMOVE ALL
SOURCES OF IGNITION. STAY UPWIND. ABSORB WITH INERT MATERIAL. FLUSH
AREA WITH WATER. VENTILATE AREA FOR AT LEAST 24 HOURS OR UNTIL AREA
HAS BEEN DECLARED SAFE .
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP CONTAINERS CLOSED AND UPRIGHT TO
PREVENT LEAKAGE. AVOID FLAMES, WELDING, OPEN LIGHTS, ETC. AVOID
BREATHING OF SPRAY MIST. AVOID SKIN/EYE CONTACT.
Other Precautions:DO NOT USE IN CONFINED AREAS, TANK OR PIT OR WITHOUT
ADEQUATE VENTILATION.

Respiratory Protection:IF VENT DOES NOT MAINTAIN EXPOS BELOW TLV (PEL),
USE NIOSH/MSHA APPROVED UNITS. USE UNITS PER CURRENT 29 CFR
1910.134 & FOLLOW MFRS DIRECTIONS/WARNINGS. IF W/IN OSHA PROT
FACTOR, NIOSH/MSHA APPRVD AIR PURIFYING OV/FILTER UNITS OK FOR
USE.
Ventilation:LOCAL AND MECHANICAL EXHAUST.
Protective Gloves:RUBBER GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYE BATH AND SAFETY SHOWER.
Work Hygienic Practices:MAINTAIN GOOD PERSONAL HYGIENE. DO NOT USE IN
CONFINED AREAS W/OUT ADEQUATE VENTILATION.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

HCC:F4
Boiling Pt:B.P. Text:310F,154C
Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Spec Gravity:1.6 (H2O=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:ESSENTIALLY NIL
Appearance and Odor:VISCOUS LIQUID WITH TYPICAL PAINT ODOR

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:FLAMES, SPARKS, SMOKING AND HEAT.
Hazardous Decomposition Products:CO, CO2.

Waste Disposal Methods:USE INERT ABSORBENT MATERIALS ON SPILLS. DISPOSE
IN ACCORDANCE WITH ALL FEDERAL, STATE, AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.